How Do I Wire The Electrical System For An HHO Cell In My Truck?
May 17, 2008 by Ryan D | Posted in Maintenance & Repairs
I demand to know a SAFE & SIMPLE way to run the electrical wiring for an HHO system into my 1985 Chevy Scottsdale. I don't privation to incorporate manual on/off switches in the dash. I just want it to turn on when the truck is event, and off when
Run the cause (black) to the negative battery terminal.
Run the hot (red) to a toggle switch on your dash and then another hot line from that change-over to the positive terminal on your battery. You will want to have an inline fuse on your hot
Aug 21, 2008 by stimpy0475 | Posted in Maintenance & Repairs
Hello,
I've made my hho part but need to apply a efie or a map sensor tuner to my vehichle. The directions give you a rough tuning operation but how can I with out a dought tune on in to prevent an over lean mixture. Also andother side question
Hi,
Unadorned Air/Fuel Gauges can be purchased or made to monitor the Mixture. Check out Trademe or any Performance Auto Workshop.
Hope this is helpful. Check site below for DIY meter.
Run the cause (black) to the negative battery terminal.