Oct 28, 2008 by Bob | Posted in Maintenance & Repairs
I have a 98 subaru legacy and I'm about to try my destiny with the HHO gas. I've tried to do as much research as I could but can't really figure out if I need a MAP sensor or and efie or exactly what the difference is between what they do.
The EFIE manipulates the voltage from the Oxygen Sensor to the ECM.
By adding 200-200mv to the signal we can bad out the vehicle.
You need to find out if your vehicle has a MAP Sensor or a MAF Sensor.
Can Anybody Install An HHO System In The Dallas Area Including A MAP Sensor, An EFIE, And A PWM?
Oct 25, 2008 by aksmith446 | Posted in Maintenance & Repairs
a web location or something could help. or a descriptive diagram or video or something would help.
We have let go diagrams and installation instructions available on our myspace page: http://www.myspace.com/trinityenergies
On older vehicles, it is as per usual a very simple 30 or so minute project for an amateur. If you don't know where
Do I Really Need An EFIE, A MAP Sensor, And An O2 Sensor For My HHO System To Run Properly?
Oct 24, 2008 by aksmith446 | Posted in Maintenance & Repairs
why. and who can ease me install one in a 98 jeep grand Cherokee?
Your agency already has the o2 sensor and Map sensor.
You are probably referring to an Electronic Fuel Injection Enhancer (EFIE) which manually adjusts your channel's O2 sensor's voltage in order to lean the fuel to oxygen ratio.
Any One Have Any EFIE Experience My Question Is Can I Use It For Gas Savings Without Using HHO Generator ?
Nov 15, 2008 by travis h | Posted in Maintenance & Repairs
can i simply use the EFIE to control my stoich and decrease my fuel consumption without adding HHO or do i have to have it and HHO i will eventually move onto HHO but am doing it slowly can i by a hair's breadth start with the EFIE or will there be no
It is not recommended. The EFIE gives your O2 sensors a faulty reading allowing you to lean your gas. If you are not providing the engine with addition fuel, such as HHO, your engine will run too be biased towards. This will reduce your HP and cause various
Aug 21, 2008 by stimpy0475 | Posted in Maintenance & Repairs
Hello,
I've made my hho portion but need to apply a efie or a map sensor tuner to my vehichle. The directions give you a rough tuning technique but how can I with out a dought tune on in to prevent an over lean mixture. Also andother side question
Hi,
Uncontrived Air/Fuel Gauges can be purchased or made to monitor the Mixture. Check out Trademe or any Performance Auto Research.
Hope this is helpful. Check site below for DIY meter.
The EFIE manipulates the voltage from the Oxygen Sensor to the ECM.